3M COMMAND

HOOK AND STRIPS



Get the most out of Command™ Products with these simple instructions and demonstrations.







- How to apply the command tape


Hooks with clear strips blend in seamlessly allowing you to show what matters most, your decor, not how it's hung up.


Clear strips work best on smooth
surfaces. Clean with isopropyl rubbing
alcohol by wiping gently. Don't use
household cleaners like wipes or sprays
because they leave behind a slippery
residue.

Separate the strips and remove
the black liner—it's the one marked
"Wall Side". Now press the strip
directly onto the wall where you
want to hang your hook. Press
along the entire strip for 30 seconds.

Finally, remove the blue liner
and press the hook onto the
strip firmly for about 30 seconds.
The harder you press, the stronger
the adhesive bond will be. Wait 1
hour before hanging.




- How to remove the command tape


Hold the hook gently in place (so it
doesn't snap your fingers!) but don't
press it against the wall.

Remember to never pull the strip
towards you. Always pull straight down as
slow as you can.

Slowly stretch the strip straight down,
keeping your hand against the wall
as you go. Keep stretching up to
30 cm until the hook releases
from the strip